Vessel Centering Gauge for ASTM and USP Validation.

Ensure your vessels are perfectly centered!

• Quickly and easily mounts in all vessel positions
• Stationary, easy to read dial
• High accuracy – one division = 0.05mm
• Range of >4mm
• Works with all instruments that have access to the vessels in the operating position

Measuring vessel centering

Accurate centering is an essential part of dissolution equipment validation. Many centering devices do not accurately take into account the actual position of the shaft in the vessel, or the vessel in the base plate.

The QLA Centering Gauge fits directly into the shaft drive. The PTFE coated lever is lowered into the vessel, approximately half way down. (It is important not to measure centering near the top of a vessel because of errors in the glass at this point).

The shaft is rotated slowly (25rpm) and the lever moves around the inside of the vessel. Deviation from the centre position can then be read on the dial, which always faces forwards. Acceptable values are ±2mm from the centre point.

Full instructions for both installation and operation are included.